SATEL BRACKET C GY Set of wall brackets for outdoor sensors: OPAL Plus, OPAL Pro, AOD-200 (grey colour, angle bracket and ball joint)

Set of wall brackets for outdoor sensors: OPAL Plus, OPAL Pro, AOD-200 (grey colour, angle bracket and ball joint)

The BRACKET C joint kit is designed for the installation of OPAL, OPAL Plus, OPAL Pro and AOD-200 outdoor detectors. The kit consists of two types of support: the ball joint and the corner support. The ball joint offers a wide range of vertical and horizontal adjustment. This makes it easier to find the optimal position relative to the detection zone. However, if the installation requires the detector to be fixed at 45° to the wall, the corner bracket can be used. Each of the brackets is also equipped with a tamper-proof tamper to detect any attempt to detach the device from the wall.

The brackets are available in two color versions: white - BRACKET C, dedicated to the installation of OPAL, OPAL Plus, OPAL Pro and AOD-200 detectors, and gray - BRACKET C GY - for OPAL GY, OPAL Plus GY, OPAL Pro GY, AOD-200 GY and AOD-210 GY.

Corner support:

for mounting on a flat surface (rectangular pillar, wall, internal corner of two walls)

Tilt angle between the detector base and the surface of the mounting bracket: 45°

anti-tamper element against attempts to detach the bracket from the wall

Ball joint:

for mounting on a flat surface (rectangular pillar, wall)

Angle between detector base and bracket mounting surface horizontally adjustable by 90° (+/-45°)

Angle between detector base and bracket mounting surface vertically adjustable by 60° (+/-30°)

anti-tamper contact that detects an attempt to detach from the wall, complete with 3 wires for connection to NC or NO type circuits