AWACS BS25 High-technology dual-infrared wire sensor with microprocessor management

High-technology dual-infrared wire sensor with microprocessor management, It is typically used in the external protection of balconies, verandas, covered sites or in protections interiors of industrial premises, cargo loading and unloading compartments, stairwells, etc. Typical flow rate 12 m, detection on 80 degrees in two planes with 9 sensitive zones, possibility of orienting the angle of optical detection (notches from 1 to 5)

Double infrared wire sensor, with advanced technology with microprocessor management, is typically used in the external protection of balconies, verandas, covered sites or in the internal protections of industrial premises, loading and unloading compartments, stairwells, etc. Typical range 12 m, detection on 80° in two floors with 9 sensitive zones, the possibility of orienting the angle of detection of the optics (notches from 1 to 5). The alarm condition occurs when both lenses are interested in the event. Sensitivity selection is provided on 4 levels (DIP2/DIP3). By setting the DIPs, it is possible to enable the anti-masking of the IR sections (DIP4) and the detection threshold (DIP10), enable shock tampering (DIP5) and sensitivity (DIP7), analysis time from the first event from 2 to 4 seconds (DIP6), it is possible to carry out a shock sensitivity test (DIP8), the possibility of choosing 2 pulses or a single pulse of the infrared part (DIP9) and combined test of the two IR sections (DIP1). On board LED and buzzer x the optical sections test

Timed exits 2 seconds. In the terminal block there are 4 solid-state relay outputs, maximum 50mA, including Alarm output, Mask output, Shock output, Tamper output, cover opening or tearing. Temperature compensation for IR sensitivity. If the sensor is attached to the wall, one of the mounting points (on the right at the top) acts as a tear-proof device.
Housing made of shock-resistant and UV-resistant material. As standard, this sensor mounts an animal array lens and must be mounted 1 meter high from the base. You can use vertical barrier lenses with a 2.1 m mount, or a long range of 30 meters with a mount ranging from 1 m to 2.1 m, or volumetric lenses with a 2.1 m

Technical characteristics