DimBox DX4 Universal dimmable actuator (RLC, LED, CFL) for DIN rail

ZENNIO ZDIDBDX4 DimBox DX4 Universal dimmable actuator (RLC, LED, CFL) for DIN rail

MT Code: ZNN_ZDIDBDX4
Manufacturer Code: ZDIDBDX4
Brand: ZENNIO

<p/the ZENNIO DimBox DX4 is a universal 4-channel adjustment actuator for mounting on a DIN rail, designed to handle RLC, LED and CFL loads.

Key Features

This actuator can handle up to 300 W per channel at 230 VAC (200 W at 110 VAC). In addition, it allows the dual connection of channels, up to 600 W at 230 VAC (400 W at 110 VAC), and the quadruple connection of the channels, up to 1200 W at 230 VAC (800 W at 110 VAC).

Load Detection and Control

The actuator has an automatic load detection function (RLC) and allows the configuration of the adjustment curves for LEDs and CFL.

Manual Control and Logical Functions

The buttons on the cover allow manual control of the outputs. In addition, the actuator includes 10 independent logic functions.

Anomaly Detection

Short circuit
Overvoltage
Overheating
Abnormal frequency
Incorrect settings

Installation and Security

The installation must be carried out only by qualified electricians and in accordance with injury prevention regulations. It is important not to connect the main voltage (110-230 VAC) or other external voltages to the KNX data bus, as this could compromise the electrical safety of the entire KNX system.

After installation, the device must not be accessible from outside. If the load changes, disconnect the main voltage (110-230 VAC).

Always ensure during installation that there is adequate insulation between the conductors of the main voltage 110-230 VAC and the conductors of the KNX bus and its extensions.

Do not expose the device to rain or moisture and do not block ventilation openings.

Data Sheet